Page 1 of 1
Configuration reset on pc startup
Posted: May 21st, 2011, 6:20 am
by kabbalah
Hi, my sabnzbd configuration seems to reset on every pc startup. sab starts on default port and shows the Quick-Start Wizard. After using it and restarting sab (for port change) it works fine until the next pc startup. I have been upgrading from 0.6.0.
Version: 0.6.1
OS: Windows 7 x64
Install-type: Windows Installer
Skin (if applicable): Plush
Firewall Software: Windows buildin
Are you using IPV6? not in sabnzbd
Is the issue reproducible? yes, every pc startup
Re: Configuration reset on pc startup
Posted: May 21st, 2011, 7:47 am
by sander
kabbalah wrote:
Hi, my sabnzbd configuration seems to reset on every pc startup. sab starts on default port and shows the Quick-Start Wizard. After using it and restarting sab (for port change) it works fine until the next pc startup. I have been upgrading from 0.6.0.
Version: 0.6.1
OS: Windows 7 x64
Install-type: Windows Installer
Skin (if applicable): Plush
Firewall Software: Windows buildin
Are you using IPV6? not in sabnzbd
Is the issue reproducible? yes, every pc startup
SAB will start the setup wizard if it can't find the sabnzbd.ini. So, after a reboot of your Win7, does %userprofile%\AppData\Local\sabnzbd\sabnzbd.ini exist? If so, how big is it and what does the content look like?
If not, can you write to that directory (assuming your run SABnzbd under your own account)? Can you create %userprofile%\AppData\Local\sabnzbd\sabnzbd.ini by hand (just an empty file)? Does it exist after a reboot?
Re: Configuration reset on pc startup
Posted: May 21st, 2011, 12:18 pm
by kabbalah
Thanks for you fast response.
I think i may have found the source of this problem. I had a link to the exe in my autostart Start Menu folder for the older version. I guess 0.6.1 installation added another link there as well. After deleting my old link the problem is gone.