SAB not downloading, but also not paused

[AndyCool22]

i'm running on windows 10.
SAB drops to 0mb/s, but is not paused, and there are things in the queue.
Connections show that it is connected, and a reboot of the PC kickstarts it again for a few minutes before it quits again....

Not sure what's going on?

Today i tried renaming the sabnzbd.ini, and it recreated a fresh one, still pulled in my queue, but still ''stopped'' without pausing.




https://andycool22.xyz/sab/sab-log.txt

[sander]

Firewall kicking in?

[safihre]

Are you using SABnzbd 4.2.1? Could be a bug that was present in 4.1.0 regarding article sizes.
Just to be sure, enable Debug logging in the Status window.

[AndyCool22]

firewall is a possibility - i had sabnzbd allowed on the private network but not public, and network had switched itself to public...
was having issue on 4.1.0 and updated to 4.2.1 and still had issue. i might try rolling back to older than 4.1.0?

[safihre]

No need to roll back.
Just enable Debug logging and inspect or share the logs after it's stuck for some time.

[AndyCool22]

when it ''stops'' the line i am noticing says

Code: Select all

2024-01-09 11:13:14,132::DEBUG::[downloader:831] Delayed - 342 seconds - Assembler queue: 12

https://andycool22.xyz/sab/sabnzbd.log

[safihre]

What drives are you downloading to?
The only reason I see this could happen is IO lockup, due to bad disk or a bad disk driver.
You use quite some non standard paths, makes me assume a special setup. What if you keep everything on the regular internal drive?

[AndyCool22]

nothing too fancy, but i don't have anything pointing to the C drive. I am assuming a combo of firewall and low disk space, once i cleared both those things up and restarted SABNZBD again, my queue completed and cleared overnight. thanks for all your help!