New DSM 7 package released - Invalid File Format
Posted: September 5th, 2021, 10:12 pm
Hi,
I've seen that this is only 14 hours after being published, however, upon trying to install this via Synology's package centre, I am getting "Invalid File Format. Please contact the package developer"
Since upgrading and seeing that it wasn't supported as of yet, I've been checking back daily. Pretty keen to get this working again natively on the NAS (DS1817+) i.e. not dockerised
Happy to try and install this via cli but ideally via the GUI would be better.
Apologies if I've misunderstood the "published" status presented here in Pull Request #4748 (github)
As an aside, I had uninstalled the package since the repair had failed in an attempt to do a clean install, so not sure if the status above implies you already have it installed and just need to repair.
Any assistance would be appreciated.
Cheers,
Junkt0wn
I've seen that this is only 14 hours after being published, however, upon trying to install this via Synology's package centre, I am getting "Invalid File Format. Please contact the package developer"
Since upgrading and seeing that it wasn't supported as of yet, I've been checking back daily. Pretty keen to get this working again natively on the NAS (DS1817+) i.e. not dockerised
Happy to try and install this via cli but ideally via the GUI would be better.
Apologies if I've misunderstood the "published" status presented here in Pull Request #4748 (github)
As an aside, I had uninstalled the package since the repair had failed in an attempt to do a clean install, so not sure if the status above implies you already have it installed and just need to repair.
Any assistance would be appreciated.
Cheers,
Junkt0wn