SABnzbd Forums

Hello all,

I'm a long time sabnzbd user and have an issue. My old system hardware died on me, but I had a good backup and copied my sabnzbd install and config from the backup to my newly built system. Everything looks the same and is working great, but I have one problem that is plaguing me and I can't figure out - it's not joining the files any longer in post processing. I didn't use any post process scripts, everything was handled within sabnzbd. I'm running linux (debian). Does anyone have any ideas to point me in the right direction?

I looked into moving to nzbget, but I really prefer the sabnzbd interface and would prefer to stick with it if at all possible!

Thank-You very much for any help.
Jack

Could you send an example NZB that isn't joining to safihre@sabnzbd.org?

Sent....

Thank-You for looking at this for me. It's baffled me! :-)

I've tried a few more. So far every nzb I've tried is doing the same thing.. Here's my switches, if it helps:



Thanks!

Thanks for trying to look into this. I found the issue, something was wrong with my rar/unrar install on the new system. All is working well again!