Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings.
Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
I run sabnzbd on my Synology DS212+ and since updating from 0.6.x to the latest release it does not unpack archives anymore. The downloads are put in the correct folders but they won't unrar. This happens for all files I am downloading, not just for some.
Would anyone be able to point me to the options where this is enabled?
I have set "Categories" to +delete, in "Switches" -> "Post processing" I have ticked the box with "Enable unrar" & "Enable unzip".
Stopped sabnzbd on my Synology and uninstalled it.
Re-installed it. After running it again I was unable to change any temporary or final destination DL folders. So, uninstalled once more and when I tried re-installing it wouldn't let me. Something about port 8080 being busy. I did not stop sabnzbd prior to uninstalling so I rebooted my disk station.
Re-installed sabnzbd once more, was able to configure proper destination folders and now everything is working as intended. My unpacking issue is also resolved.
For all other users with this problem, there are two versions of sabnzbd available on the Synology package center. I assume it is because I have several custom sources defined. I run the version of the SynoCommunity now. They both say "0.7.16"!
