SABnzbd Forums

Recently installed FreeNAS and was able to install SABNZBD with a PIB file that someone created. However that PIB file only contained version 0.7.7. While this version is working i would like to upgrade it to the next version.

The "Update Available" alert that pops up just takes me to the website to download, however FreeNAS runs in the LINUX enviroment and i am new to that area. I stumbled around in Putty and found a sh script called "sabnzbd-update.sh" and ran it...system says it downloaded but i am unsure on how to figure out where it put it or how to run it and when i reboot SABnzbd its the same version.

I have scoured the forums but i am not finding someone with a similar problem. If i missed it apologize but i am at a loss right now on how to upgrade.

again i am new to LINUX so if its a basic command that i am missing i would appreciate any help.

ksman

Try to check related post on FreeNAs forum > http://forums.freenas.org/showthread...ll=1#post41479
my steps was follow:
1) Run Shell in FreeNas webGui
2) define your pluguin jail ID by "jcs"
3) You will see Your pluginJail ID and folder path
4) after that run "jexec x csh" where x is Your ID number (propably 1)
5) define postion of Sabnzdb in Your jail with "cd /usr/pbi/sabnzbd-`uname -m`"
6) run "ls" and check You see sabnzbd-update.sh if Yes,
7) run update by "sh sabnzbd-update.sh"

You will se progress of update, after that check if everything works as You wish, If you have problem with permission, make additional change. Good luck!

I had not tried it in the freenas gui..i just kept running it via putty. Do you think the the gui will allow it to execute properly where the putty does not?

Hard to say... I'm also linux/BSD n00b but I made it today throug WebGui shell and everything is done....

Thanks for your help. Running it through the FreeNAS shell works by following those steps. Evidently you cant putty in and do it.

In FreeNAS-9.2.1.6-BETA-ec7b399-x64 there's a sabnzbd pluginjail to install.
There's no upgrade script included here.
Any hints on how to do the upgrade from 0.7.7 to a newer version here ?
Can I download the script you're using somewhere ?