Page 1 of 1
mass retry post-processing
Posted: May 5th, 2013, 12:06 pm
by thedude2222
I am moving my files after download onto a separate disk which uses a special software "raid" called flexraid. But it's still a little buggy and every now and then it will not allow creation of new folders. So all post processing fails until I notice and manually fix the problem. It's really annoying to hit retry over and over on each job. It would be nice if there was a retry all button.
This would also be nice for anyone moving files to a separate disk which becomes full.
Re: mass retry post-processing
Posted: August 17th, 2013, 7:37 pm
by nobrumski
I would love to see this happen since I just ran into something similar. As a result I have a large hiostoy of failed downloads that didn't truly fail. If I could check all like I can for pause, resume, and delete in the active queue, it would help.
Re: mass retry post-processing
Posted: August 19th, 2013, 1:25 pm
by shypike
Something for a later release, not for the 0.7.x series.
Re: mass retry post-processing
Posted: December 28th, 2014, 4:56 pm
by zion2k
Hello,
any further news about this feature? I am really looking forward to it.
Re: mass retry post-processing
Posted: December 29th, 2014, 5:18 am
by shypike
Likely in the next major release, 0.8.0.
A few more weeks before the first Alpha release.
Re: mass retry post-processing
Posted: January 5th, 2015, 4:01 am
by sabnzbler
This function will be very nice.
Have to retry hundreds on a permission problem with my new disk.
Re: mass retry post-processing
Posted: January 11th, 2015, 11:17 am
by shypike
Implemented for 0.8.0