Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings.
Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
I connected to gogo6 ipv6 tunnel over the build in tunnel.
With this I was able to download from reader.ipv6.xsnews.nl after I added my reader.ipv6.xsnews.nl logindata to the build in downloadmanager, so i thought SABnzbd would work.
Oops. Sorry. I should have scrolled down in your ifconfig output: "inet6 addr: 2001:c08:3700:ffff::1f:b8c0/128 Scope:Global". That's good!
How were you able to download from reader.ipv6.xsnews.nl?
If you like our support, check our special newsserver deal or donate at: https://sabnzbd.org/donate
Hyper1on wrote:
I upgraded to Python 3.1.3 and tried again.
SABnzbd will not run properly on Python 3.x (it's incompatible with 2.x).
Well, thats my problem, I tried 2.x and it didn´t work. Switched back to 2.x.
Looks like the integrated tunnel isn´t working correctly, otherwise SABnzbd should connect correctly I think.
Was trying to install a AICCU connection, but couldn´t get it to work yet.
I have a similar problem.
Some days ago I changed my provider (faster internet access) and got a new modem/router.
Most of my hardware and software works except two packets on my Synology 2.10+ with DSM 3.0 new release.
Sabnzbd 0.5.4 gives NoneType' object is unsubscriptable and also my Squeezebox Server fails (only internetradio, not my music map).
I re-installed Sabnzbd, but Test Server still gives the same error.
I installed Sabnzbd 0.5.6 on my desktop computer and - suprise - that works, however not my NAS-version. My desktop and also my Synology are connected by wire.
