Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings.
Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
I've just noticed if I attempt to add a personal note to a server that is not yet fully configured, I get a 'failed' message as the "server address xxx:119" is not valid". This is correct - I often include a dummy server address while I'm testing SAB package installation and upgrading.
But, is it really necessary to validate settings before allowing them to be saved?
We have a separate button for 'Test Server', so the user can check the validity of their settings whenever they like. I don't think there's a need to restrict saving all server settings just because the server address isn't valid. The same dummy address was configured during the initial wizard setup and was accepted without error.
We only check a very few fields to be there. If they aren't there, it might break the code in a later stage.
So rather than allowing bad settings, we just reject them.
I am surprised that it worked during wizard, the saving should go through the same code. Although now I am starting to doubt that
If you like our support, check our special newsserver deal or donate at: https://sabnzbd.org/donate
