Do you experience problems during downloading?
Check your connection in Status and Interface settings window.
Use Test Server in Config > Servers.
We will probably ask you to do a test using only basic settings.
Do you experience problems during repair or unpacking?
Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
I just experienced a behavior that I think maybe could be solved easily:
After adding an nzb file I switched SAB to pause. Then I had to restart my NAS. When it came up again and SAB was running, it was starting to download automatically.
Is there a switch where I can tell SAB to recognize it´s old status? If it was paused and restarts it should be paused again and not starting the download.
You can tell it to always start paused, and if you use the Restart from within sabnzbd, it will remember it.
But not when you restart the device, we assume this is a user action and that the user can take care of it
If you like our support, check our special newsserver deal or donate at: https://sabnzbd.org/donate
